Test Run
Step
Check the power supply
1
voltage
Turn the ground-fault circuit
2
interrupter "ON"
Insert your hands to check if air is
3
being blow.
4
Instructions given to customer
Explain how to use the jet dryer to customer according to the instruction manual. Especially request customer to
●
observe the important safety instructions in "Safety Precautions".
Provide customer with this installation manual after completing installation.
●
If user is not there, give instructions to caretaker.
●
Tokyo Building 2-7-3, Marunouchi, Chiyoda-ku, Tokyo 100-8310, Japan
What to check for
Is the proper power being used?
(
Single-phase 120V AC
Incorrect power supply may cause malfunctions or low
wind power.
Are any lights in the display on?
Is the air blowing?
Is warm air blowing?
( Even if the heater switch is "ON", the heater may not operate
if it is used continually.)
※ As the heater is a simple heater, the air may not feel so
warm if the room temperature is low (20°C or below).
Is the unit mounted securely without any vibration or abnormal
noises?
− NA - 13 −
- 16 -
- 13 -
)
Check