Removal/Fitting The Lid; Mark Up Mounting Holes Using Drilling Template; Expanding The Controller With More Wiegand Modules - HID ACW2-XN Installation Manual

Web-based access control solution

Hide thumbs Also See for ACW2-XN:

Table of Contents

Removal/Fitting the Lid

Open the lid &

unplug the cable

Select fasteners that are appropriate for the mounting surface (masonry/wood/ dry wall)

2. Select the drill size appropriate for the fasteners

3. Fix the Drilling Template against the chosen vertical surface (using the supplied double-sided tape),

making sure that the top edge is horizontal. (Remember to allow 30 mm clearance on the left of the

ACW2-XN enclosure to allow the door to hinge fully open.)

4. Centre punch the two mounting hole locations

5. Drill holes of a diameter that is suitable for the fasteners

6. Remove the lid from the enclosure (as per instructions above)

7. Mount the enclosure to the surface

8. Replace the lid (and plug the lid cable back in) after the system wiring is complete

9. Place the AC and AW2 module labels in the correct positions provided on the back page of the

ACW2-XN Quick Install Guide. The information on the labels will be used during the door

configuration process via HID Access Manager.

The ACW2-XN comes assembled with one AW2 module, and can support another three AW2 modules.

Additional AW2 modules are plugged into the sides of the existing modules, and then fastened in place

with the four mounting screws that are included with each AW2 module.

Remember to place the additional AW2 Module labels on the back page of the ACW2-XN Quick Install

Guide

Note:

•

AW2 modules may be added or removed without powering down the system.

Web-Based Access Control Solution

Slide the lid upward

Installation Guide

ACW2-XN

Remove the lid

Page 7 of 26

Table of Contents