Controller Module; Cable Specifications; Key Components And Connections - HID ACW2-XN Installation Manual

Controller Module

Cable Specifications

Application
Network
RS-485

Key Components and Connections

Enclosure Anti-Tamper
(Pre-Wired)
DIP Switches
Factory set for
Master (0100)
Battery Tag
REMOVE before
powering up the system
Note:
•
Any module that has changes made to its DIP Switch settings while already powered up must be
powered down and powered up again. This is because the settings are only read by the module
during the power up cycle.
DIP-switch Position
© 2018 HID Global Corporation All rights reserved.
Conductors
8
Twisted pair, with or without screen
Function MODE
Slave Controller Mode
0000
Master Controller Mode
0100
Web-Based Access Control Solution
Max Cable
Cross Section
Length
2
>= 0,75 mm 150 m
2
>= 0.51 mm 1 000 m
RJ45 Network Socket
12 VDC Supply
(Pre-Wired)
Earthing Terminal
(See page 12 for details)
Device RS-485 Terminal
This is used for linking
the Master Controller to
the Slave Controller
Host RS-485 Terminal
Reserved for future expansion
Installation Guide
ACW2-XN
Page 11 of 26