Wiegand Module (Aw2); Inter-Module Communications; Battery Charging Circuit - HID ACW2-XN Installation Manual

Controller module (AC1) continued...
RS-485 Ports (Device & Host)
Interface
RS-485

Wiegand Module (AW2)

Power (At 12V)
Conditions
Relays idle, No readers Connected
Both relays activated, maximum reader load
Relays
Contact
Rating
[10A, 28VDC]
[5A, 220VAC]
[12A, 120VAC]

Inter-Module Communications

Connector
10-way connectors:
Female on the left, male on the right
Wiegand Reader Port
Connector
10-way Screw Terminal Plugs

Battery Charging Circuit

Conditions
Supply at 12V DC, battery flat, max charge current
Calculations
The following calculation must be performed for each additional DC power Supply, together with all locks
that are powered from that power supply.
*Note: See individual lock and power supply installation manuals for current consumption and maximum
current output.
12 V Power Supply max current
© 2018 HID Global Corporation All rights reserved.
Baud Rate Data Format
38 400 8 data bits, no parity, 1 stop bit
Configuration Contacts
Double Pole
NO, NC, COM
Single Throw
Reader Connections
12V, 5V, 0V, D0, D1, LED (Red), LED (Green), Buzzer, Hold,
Shield
output
Maximum lock current total
Margin
Web-Based Access Control Solution
Current
37 mA
503 mA
Operations
> 100 000 (with MOVs installed across
12V inductive loads – see page 8)
Purpose
Power and data lines to other modules
Current Power
500 mA 6 W
-
(The margin may not be negative.)
Installation Guide
Power
0.44 W
6 W
Page 19 of 26
ACW2-XN