Table Of Contents; Unpacking The Equipment; Tools Needed - Johnson Controls S321-IP Hardware Installation

S321-IP Network Controller
24-10239-480 Rev. F
S321-IP H
ARDWARE
The S321-IP controller communicates with the host via Ethernet. It supports up
to two doors per unit and allows you to configure supervised 4-state inputs and
unsupervised 2-state inputs. The S321-IP controller provides power for the card
reader hardware; it does not provide power for the door locking hardware.
A T D
BOUT HIS OCUMENT
This document describes S321-IP hardware installation, basic operation, and
maintenance procedures. It is divided into the following sections:
• Unpacking the Equipment
• Tools Needed on page 1
• Mounting on page 2
• Description of Signals
• Cable Requirements
• Basic Commissioning
• The S321-IP User Interface
• Technical Specifications
• Maintenance on page 20
U E
NPACKING THE
Inspect the S321-IP shipping containers as soon as you receive them, with the
delivery agent present. If a container is damaged, open it immediately, inspect
the contents, and have the agent make note on the shipping document. Check
the purchase order against the packing slips to ensure the order is complete. If
the contents of a container are damaged, notify the carrier and your
Johnson Controls representative immediately. Report any discrepancies to your
Johnson Controls representative. Save the packing materials for possible return
shipments.
Your package should contain the S321-IP controller, connectors set, a CD
containing a set of user documentation, and this manual.
T N
OOLS EEDED
Use a small, straight-blade screwdriver to secure wires in the terminal blocks.
I
NSTALLATION
on page 1
on page 5
on page 7
on page 10
on page 16
on page 19
QUIPMENT
1
Hardware Installation