Log Settings (Debug Levels); Set Log Levels - NEC UX5000 Installation Manual

UX5000
___________________________________________________________________________________
___________________________________________________________________________________
Multimedia Conference Bridge Installation Manual
6.1.5

Log Settings (Debug Levels)

6.1.5.1

Set Log Levels

The Set Log Levels window allows the installer to configure
how much information should be sent to the debug log.
This window is used for analyzing any communication errors,
and is intended for use by technical support personnel.
There are three components of the conference bridge for which
the log levels can be set. These include:
❍
❍
❍
✎
The three components can be set to one of the following log
levels. Log messages are categorized from highest level to
lowest as listed below:
❍
❍
❍
❍
❍
Figure 5-21 Set Log Levels Window
Interface Log Level
Application Log Level
Engine Log Level
The maximum size of the rotation log is 1 MB.
None = no messages are logged.
Error = all error messages are logged.
Warning = all warning and error messages are logged.
Information = all information, warning and error messages
are logged.
Debug = all levels of messages are logged when 'debug'
level is set .
Issue 1.0
5 - 29