Editing Partially On A Dv Tape - Dv Synchro-Editing - Sony Handycam DCR-PC3 Operating Instructions Manual

Editing partially on a DV tape
– DV synchro-editing
By simply selecting the scenes to edit, you can duplicate the desired portion on a tape,
using other equipment connected with an i.LINK cable (DV connecting cable). The
scenes can be selected by frame. You can also use the Remote Commander for this
operation. Since your camcorder exchanges digital signals, you can edit with little audio
and video deterioration.
You cannot duplicate titles, display indicators, or the contents of cassette memory.
The connection is the same as on page 56.
(1) Insert a recorded tape into your camcorder and insert a blank tape (or a tape
you want to record over) into the DV product.
(2) Connect your camcorder to the DV product with an i.LINK cable (DV
connecting cable).
(3) Set the POWER switch on your camcorder to VTR.
(4) Set the input selector to DV input on the DV product. If the DV product is
another DV camcorder, set its POWER switch to VTR.
(5) Press FN on your camcorder to display PAGE1 (p. 15).
(6) Press MENU, then select DV EDITING in
(7) Using the control buttons, locate the point where you want to start editing,
then press
(8) Press MARK on your camcorder or the Remote Commander to set DV
EDITING IN.
(9) Using the control buttons, locate the point where you want to end editing, then
press
(10) Press MARK on your camcorder or the Remote Commander to set DV
EDITING OUT. The editing process starts. When the process ends, your
camcorder and the DV product automatically set to pause mode.
7,9
5
FN
to set your camcorder in the playback pause mode.
to set your camcorder in the playback pause mode.
8,10
MARK
in the menu settings (p. 76).
DV ED I T I NG DV ED I T I NG 0 : 23 : 12 : 01
I N OUT
MARK
END
x m N X M
DV ED I T I NG DV ED I T I NG 0 : 25 : 20 : 05
I N OUT
MARK
END
x m N X M
57