Audio dubbing
Adding an audio sound on a recorded tape
Choose a connection mentioned before, and connect audio equipment or microphone to
your camcorder. Then follow the procedure below.
(1) Insert the recorded tape into your camcorder.
(2) Set the POWER switch to VCR on your camcorder.
(3) Locate the recording start point by pressing N. Then press X at the point
(4) Press AUDIO DUB on the Remote Commander. The green
(5) Press X and start playing back the audio you want to record at the same time.
(6) Press x at the point where you want to stop recording.
Monitoring the new recorded sound
To play back the sound
Adjust the balance between the original sound (ST1) and the new sound (ST2) by
selecting AUDIO MIX in
Five minutes after when you disconnect the power source or remove the battery pack,
the setting of AUDIO MIX returns to the original sound (ST1) only. The default setting
is original sound only.
88
where you want to start recording to set your camcorder to the playback pause
mode.
appears on the screen.
The new sound is recorded in stereo 2 (ST2) during playback. During
recording new sound, the red
AUDIO DUB
appears on the screen.
in the menu settings (p. 96).
V CR S E T
H i F i SOUND
A UD I O M I X
A / VcD V OU T
ST1
ST2
R E T URN
[ ME NU ] : E ND
X indicator