Table of Contents
Advertisement
The via control signals setable minimal and maximum values for wire feed speed (MIG/MAG) /
welding current (TIG) depend on the job specific settings of parameters DV-MIN/DV-MAX /
RANGE-MIN/RANGE-MAX. With this, the upper and lower limits can be set (in the PC300 theses
parameters refer to the expert model constants).
With the previous RINT X11 control, it was necessary to activate the signal for control signal
mode and select program number 0. With RINT X12, it is no longer necessary to additionally
select program 0.
As a special feature, control signal default settings by an alternative control such as Expert 2.0 or
by a remote control are possible when the control signal mode is disabled and program 0 is set.
099-000769-EW501
29.06.2015
Design and function
Chosing the process logic
23
Advertisement
Table of Contents
Need help?
Do you have a question about the RINT X12 and is the answer not in the manual?
Questions and answers