The Diagnostics Interface; Pc System Requirements; Commissioning; Scope Of Diagnostics - EWM RINT X12 Operating Instructions Manual

6

The diagnostics interface

To support commissioning processes and the analysis of signal sequences, the RINT X12 has a
diagnostics interface that is connected to a PC USB port and can be evaluated using the EWM Analyzer
software.
6.1

PC system requirements

6.2

Commissioning

Requirements for commissioning the diagnosis interface are:
•
The connection cable for the PC USB port (consisting of SECINTX10USB filter box, item no. 090-
008190-XXXXX and PCV5-I connection cable, item no. 094-001205-XXXXX) must be connected to
the PC and to the adapter cable required for the connection to the 6-pole Minifit X12 socket on the
RINT X12, by means of the adapter cable item no. 094-013051-XXXXX.
•
When using a RINT X12 ATCASE, the adapter cable is not necessary as the connection cable can be
inserted directly into the casing.
•
Jumper 17 must be plugged in for operation!
•
Start the program, use the Windows Device Manager to identify and set the assigned COM port.
The diagnostics are now ready for use.
6.3

Scope of diagnostics

Various information can be determined using the EWM Analyzer software. In the profile view, the
RINT X12 is shown together with its physical connections; this can therefore take the place of the
connection diagram. This allows the relevant status of the input or output to be read off immediately
(system check). For advanced time-based signal analysis, a diagnostics and monitor view of the recorded
data is available. The current software status of the RINT X12 can also be determined easily.
For more information on the Analyzer, please also see the relevant operating instructions!
099-000769-EW501
29.06.2015
The diagnostics interface
PC system requirements
35