Changing the door hinging
Changing over the spring clip
and the hinge pin
Using a screwdriver, remove the
spring clip from the bottom of the
door and fit it on the opposite side.
Remove hinge pin together with its
washer .
Important! The gap in the washer
must fit over the stub on hinge pin
so that the washer sits correctly
above the washer on the hinge pin.
Fit the hinge pin together with
washer in the door bearing bush
on the opposite side. Important! The
stub must point to the inside of the
appliance door and the gap to the
outside.
54
Refitting the door
Take the appliance door and guide
the upper door bearing bush into the
hinge pin at the top of the appliance.
Swing the door in, and fit hinge pin
into hinge plate .
Important! If necessary turn the hinge
pin so the stub points to the inside of
the door and the gap to the outside.
The hinge pin will then engage in posi-
tion.
Carefully tip the appliance back with
the help of a second person, and
screw the safety screw back in to
the support. Tighten it with the span-
ner supplied.
Realign the door with the appliance
housing again if necessary using the
long slots in the lower hinge plate.
Then tighten the screws.