Refitting The Handle - Miele FN 22062 ws Operating And Installation Instructions

Refitting the handle


The door seal will be damaged if
the handle is fitted incorrectly.
Please make sure you follow the in-
structions below carefully when you
refit the handle.
 Loosely attach the handle to the op-
posite side of the door with the two
front screws .
Mounting plate  must be positioned
on the side of the door so that when the
door is closed it is flush with the side of
the appliance.
If this is not the case:
 Turn the two pre-mounted set screws
 with a hex key until the mounting
plate  is positioned at the correct
angle.
 Firmly tighten all 4 screws .
 From the appliance side, slide the
sidebar  into the guide on the
mounting plate until it audibly clicks
into place.
Changing the door hinging
Permanent damage to the door seal.
Make sure that the sidebar  does
not come into contact with the door
seal when the door is opened.
If the sidebar does touch the seal:
 Realign the mounting plate  using
the set screws  until the mounting
plate and the sidebar  are at the
correct angle and the sidebar no
longer touches the seal when the
door is opened.
55