thomann Stairville Stage TRI LED Bundle Extension User Manual page 34

Operating
Operating mode 'Automatic'
34
Automatic operation can only be activated if the unit is working in stand-alone mode or as
master device in a master / slave combination. This setting is only relevant if the unit is not
controlled via DMX.
Press [Mode] repeatedly until the display shows 'AUTO' . Press [Setup]. Now you can select the
number of loops for the programmes to run. Use [UP] and [Down] to select a value between
'n.001' and 'n.100' .
Press [Setup] to adjust the speed. Use [Up] and [Down] to select a value between 'SP01' (slow)
and 'SP99' (fast) or 'SPFL' (flash effect).
To adjust the fade speed, repeatedly press [Setup] until the display shows 'Fdxx' . Now use [Up]
and [Down] to select a value between 'Fd00' and 'Fd99' .
To set the strobe frequency, repeatedly press [Setup]. Now use [Up] and [Down] to select a
value between 'FS00' (slow) and 'FS99' (fast).
In the automatic operating mode, the built-in programmes run one after another. To start the
automatic sequence from a specific programme, repeatedly press[AUTO]. However, it is not
possible to set a certain programme permanently as start programme.
LED lighting set