Eaton 91PS User And Installation Manual page 47

Eaton 91PS/93PS UPS 8-10 kW
1. To gain access to the terminal
blocks, remove the screws
securing the gland plate at the
back of the UPS.
2. If needed, install the additional
single feed kit. In 93PS, connect
4 wires. In 91PS, connect 1
wire.
For more information, see
Section
Warning: Do NOT apply single
feed installation to 3:1 units.
©
Eaton Corporation plc 2018. All rights reserved.
5.2
.
Revision: 003
User's and installation guide
93PS:
91PS:
Document ID: P-164000672 47 (102)