Using Compact Version Powerseat With A Fixed Anchorage - Harken POWERSEAT PWRS-G Instruction Manual

powerseat pWrs-G.compact
In the Ascent Procedure with the Compact Version the Waist strop is not used.
7. To ascend, fully press the upper red lever and at the same time adjust the speed by pressing the lower red
lever..
ATTENZIONE!
Before using the device check that the rope is correctly installed.
usInG the coMpAct versIon devIce - usInG coMpAct versIon poWerseAt WIth A fIXed AnchorAGe
NOTE!
To use the PowerSeat with a fi xed point at least two operators are necessary. One operates the
device and the second is connected by the primary rope to the device and to the secondary rope by
the (EN353/2 approved) fall arrest device. Both ropes must be EN1891 certifi ed and have a diameter
of between 10 (1/8") and 12.7 mm (1/2"). The secondary rope must have an anchorage point that
supports at least 15kN. The device is connected to a fi xed anchorage point on the ground which
must support at least 15kN.
1. Adjust the accelerator control so it is ergonomically comfortable for the operator, following the "Adjusting
the Accelerator Control Position" procedure.
2. Set the control lever position following the "Adjusting the Control Lever Position" paragraph.
3. Install the primary rope on the device as indicated in the "Primary rope installation procedure on Comapct
version" paragraph. In this case the primary rope will be used to lift the second operator.
4. Connect the anchorage point on the front plate of the device with the fixed anchorage point on the ground.
5. Place the accelerator control in the " I " position and pull the starter cord.
6. To operate the PowerSeat fully press the upper red lever and at the same time adjust the speed by pressing
the lower red lever.
25-05-18 ENGLISH
Fall Arrest
Device
Lower Front
Attachment to
PowerSeat
33