Harken POWERSEAT PWRS-G Instruction Manual page 24

powerseat pWrs-G
3. Remove the seat.
4. Adjust the accelerator control so that it is ergonomically comfortable for the operator, following the
"Adjusting the Accelerator Control Position" procedure.
5. Place the control lever position following the "Adjusting the Control Lever Position" paragraph.
6. Install the primary rope on the device as indicated in the "Primary rope installation procedure" paragraph.
In this case the primary rope will be used to lift the second operator.
7. Connect the anchorage point on the front plate of the device with the fixed anchorage point on the ground.
8. Place the accelerator control in the " I " position and pull the starter cord.
9. To operate the PowerSeat fully press the upper red lever and at the same time adjust the speed by pressing
the lower red lever.
NOTE!
Before using the PowerSeat places on the ground be sure that the cable or the stand of the accelerator
control are not under the device chassis.
24 ENGLISH 25-05-18