Harken POWERSEAT PWRS-G Instruction Manual page 23

powerseat pWrs-G
In ascent procedure 2 the Waist strop is not used
7. To ascend, fully press the upper red lever and at the same time adjust the speed by pressing the lower red
lever.
WARNING!
Before using the device check that the rope is correctly installed.
usInG the devIce - usInG poWerseAt WIth A fIXed poInt
NOTE!
To use the PowerSeat with a fi xed point at least two operators are necessary. One operates the
device and the second is connected by the primary rope to the device and to the secondary rope by
the (EN353/2 approved) fall arrest device. Both ropes must be EN1891 certifi ed and have a diameter
of between 10 (1/8") and 12.7 mm (1/2"). The secondary rope must have an anchorage point that
supports at least 15kN. The device is connected to a fi xed anchorage point on the ground which
must support at least 15kN
1. Pull the clamp and slide out the front tube.
25-05-18
Lower Front
Attachment
to PowerSeat
2. Unscrew the four screws that fix the seat to
the chassis with a n°5 hex Key.
ENGLISH
Upper front
Attachment
to Fall Arrest
23