Ascent Procedure 2 - Harken POWERSEAT PWRS-G Instruction Manual

powerseat pWrs-G
6. Place the accelerator control in the " I "
position.
8. Adjust the position of the accelerator
control so it is ergonomically comfortable
for the operator and away from the engine
exhaust. To do this, loosen the fixing screw,
position the accelerator control and retighten
the fixing screw.
ATTENZIONE!
Before using the device check that the rope is correctly installed.
usInG the devIce - Ascent procedure 2
1. Install the primary rope on the device as indicated in the "Primary Rope Installation Procedure" paragraph
2. Adjust the accelerator control so that it is ergonomically comfortable for the operator, following the
"Adjusting the Accelerator Control Position" procedure.
3. Place the accelerator control in the " I " position and pull the starter cord.
4. Start the device and position it at the height of the operator's shoulders
5. Connect the fall arrest device to the harness as described in the "Preparing to Ascent" paragraph
6. Connect the snap-hook supplied with the device to the lower front attachment point of the harness
22
7. Pull the starter cord.
Upper Lever
Lower Lever
9. To ascend, fully press the upper red lever
and at the same time adjust the speed by
pressing the lower red lever.
ENGLISH 25-05-18