Preparing To Ascent With The Compact Version - Harken POWERSEAT PWRS-G Instruction Manual

powerseat pWrs-G.compact
9. Pass the rope over the stripper arm.
11. Position the rope inside the stopper.
usInG the coMpAct versIon devIce - prepArInG to Ascent WIth the coMpAct versIon
To use the PowerSeat Compact version follow the procedure described in "Preparing to Ascent" paragraph.
WARNING!
Read carefully "Preparing to Ascent" paragraph before using the device.
usInG the coMpAct versIon devIce - Ascent procedure WIth the coMpAct versIon
1. Install the primary rope following "Primary Rope Installation Procedure on Compact version" paragraph.
2. Adjust the accelerator control so it is ergonomically comfortable for the operator, following the "Adjusting
the Accelerator Control Position" procedure.
3. Place the accelerator control in the " I " position and pull the starter cord.
4. Start the device and position it at the height of the operator's shoulders.
5. Connect the fall arrest device to the harness as described in the "Preparing to Ascent" paragraph.
6. Connect the snap-hook supplied with the device to the lower front attachment point of the harness.
32
10. Fit the rope into the rope grab. Raise the
cover to make this easier.
ENGLISH 25-05-18