Vermont Castings Encore FlexBurn 2040 Installation & Operating Manual page 8

will facilitate the removal of the chimney connector system
available from your local dealer.
Thimble Sleeve
Figure 6
cemented securely in place.
room. Use furnace cement and thin gasketing to seal the
sleeve in place in the thimble. Secure the chimney connector
to the outer end of the sleeve with sheet metal screws.
of connector are then attached with sheet metal screws.
Fireplace Installations
The chimney connector may be connected to the chimney
Above the Fireplace
®
The Encore may be connected to a chimney above a
chimney connector rises from the stove top and then angles
ninety degrees back into the chimney. The chimney liner
enters the chimney.
consideration to the following points:
mantel.
charts for other installation options.
8
Flue
Vermont Castings • Encore® Flexburn Installation Manual_R43 • 11/18
Figure 7
Through the Fireplace
may install a Encore ® through the opening using a "positive
required safe clearances for Encore
on Page 12.
Floor protection requirements also apply to fireplace
installations. Refer to the "Floor Protection" section in this
manual.
Wall Pass-Throughs
requirements.
Mantel
Seal
®
3-90-30005295