Vermont Castings Encore FlexBurn 2040 Installation & Operating Manual page 20

Fan Kit Installation
1. Attach the fan assembly at the bottom edge of the inner
2. Attach snapstat to the mounting holes on the underside
under the right front wing of the bottom heat shield with
4. Attach the rheostat to its holder by inserting the rheostat
ring and rheostat knob onto the shaft.
5. Secure the rheostat cable to the underside of the bottom
heat shield using the wire tie provided and the hole at the
right rear edge of the heat shield.
7. Plug blower cord into a grounded outlet. Do not remove
ground prong from plug. Route power cord to avoid heat
from the stove or other damage. Do not route cord under
or in front of appliance.
Tie to Secure
Rheostat
Rheostat
Rheostat
Snapstat
Figure 27
Installing or Removing Catalyst
1. Remove the access cover by gently lifting up and pulling
3. Remove the catalyst by gently pulling it straight out.
ceramic components will not be damaged.
20
Screws
Vermont Castings • Encore® Flexburn Installation Manual_R43 • 11/18
Access
Figure 28
Figure 29
Figure 30
3-90-30005295