Vermont Castings Encore FlexBurn 2040 Installation & Operating Manual page 31

Adjust the Damper as Needed
The tension on the Encore
compensate for compression of the gasket that seals the
1. Remove the griddle. Loosen the lock nut at the center of
clockwise with an Allen wrench provided with your stove.
3. Tighten the lock nut. Prevent the pressure screw from
Pressure Adjusting
Screw
Allen Wrench
Figure 44
Tighten the Damper Handle as Needed
A handle on the left side of the stove controls the damper.
The handle attaches to the damper rod with a set screw.
Periodically check the set screw and tighten as necessary.
How to Adjust the Door Latches
The front door of the stove should close securely to prevent
accidental opening and should close tightly to prevent air
positioned vertically when the door is closed.
compress and the latch may need adjustment. To adjust the
set screw.
pawl rotation.
small adjustments until the setting is right.
area. Pack more cement or a smaller diameter gasket into the
channel beneath the gasket so the main gasket is raised and
replacement are given later in this section.
31
® 's damper is adjustable to
Lock Nut
Damper
Vermont Castings • Encore® Flexburn Installation Manual_R43 • 11/18
Roller
Lock Nut
Set Screw
Flat Washer
Figure 45
Replace the Stove Gaskets as Needed
Your Encore ®
begin to lose their effectiveness. These will need periodic
replacement.
their applications.
Gasket Diameter......And the Parts it Seals
each other.
follow the standard safety procedure for working with dusty
materials: wear safety goggles and a dust mask.
of the gasket location. Follow these steps:
Shoulder Screw
3-90-30005295