Vermont Castings Encore FlexBurn 2040 Installation & Operating Manual page 7

that it rises readily.
joining sections of chimney connector.
Single-wall Chimney Connectors
keep each crimped end
pointing toward the stove.
chimney connector and
metal screws. Lift off the
stove's surface between
the griddle opening and the
the front hole.
section of chimney connector serve as guides when you
for various installations follow. Figure 5 illustrates the
general layout of chimney connector parts.
• Be sure the installed stove and chimney connector are
correct distances from nearby combustible materials.
NOTE: Special slip pipes and thimble sleeves that form
telescoping joints between sections of chimney connector
are available to simplify installations. They often eliminate
local dealer about these special pieces.
7
Toward
Stove
Flue Gas
Direction
Figure 4 -
Vermont Castings • Encore® Flexburn Installation Manual_R43 • 11/18
Elbow
Slip Pipe
Standard
Figure 5
freestanding masonry installation.
Securing the Single-wall Connector to a Prefabricated
Chimney
Follow the installation instructions of the chimney manufacturer
Special adapters are available from your local dealer to
make the connection between the prefabricated chimney and
the chimney connector. The top of such adapters attaches
directly to the chimney or to the chimney's ceiling support
chimney connector.
Securing the Single-wall Connector to a Masonry
Chimney
chimneys may be used for your installation.
Freestanding Installations
the joint between the thimble and the chimney wall must be
Flue
Thimble
"
3-90-30005295