Termination Of The Hvsc Upper End - Lightning Protection International Guardian System 5 Installation Manual

Termination of the HVSC Upper End

Tools and parts required for the completion of the HVSC Upper Termination include:
• Compression or mechanical crimping tool (for 50mm crimp lug).
2
• Sharp knife.
• Phillips Head Screwdriver.
• Shifting spanner (or 14mm spanner/socket).
• 2 x screwdrivers (used as friction cutting tool handles).
• Heat gun or Gas Torch (LPG).
• Tape measure (cm).
• Marker or pen.
• Combination Pliers/Cutters.
• Terminal Base Assembly (supplied with the Guardian CAT Terminal).
Upper Termination Kit consists of:
• Instructions.
• 1 x roll of Semi-Conductive Tape.
• 1 x 50mm Crimp Lug.
2
• 1.5 x Heatshrink Tubes (1 x 1200 & 1 x 600mm lengths).
• Insulation Friction Cutting Tool.
• Insulation Tape (1 x roll).
Upper Termination Instructions For UTERMKIT-Mk2
(Heatshrink)
The diagram on the following page (Figure 22) shows the different layers of the HVSC cable
and indicates their names as referred to in the following instructions:
28
Document 36 II Guardian Version 1.02 © Copyright 2008 LPI
Guardian Install Manual V12.indd 30 22/9/08 4:25:25 PM