Table of Contents
Advertisement
• It is very important to keep the mast straight during the lift to avoid damaging the mast.
• The Guardian CAT terminal must NOT be used as a slinging point.
• When lifting the mast, ensure that the slings or ropes cannot damage the Guardian CAT
terminal, see Figure 41.
• When lifting the mast, the HVSC downconductor must be tied off to the mast to remove any
strain on the HVSC downconductor termination to the Guardian CAT terminal.
Figure 41.
• Protect the HVSC downconductor at the base of the mast when lifting, maintain a minimum
bending radius of 500mm (20 in.) and ensure it does not drag over rough or sharp surfaces.
40
Guardian Install Manual V12.indd 42
Document 36 II Guardian
Version 1.02
© Copyright 2008 LPI
22/9/08 4:25:27 PM
Advertisement
Table of Contents
