Table of Contents
Advertisement
Upper Termination Instructions UTERMKIT-MK3
(Heatshrink) for HVSC Plus
Termination of the HVSC Plus Upper End
Note: This Document is to be used in conjunction with the UTERMKIT-MK3 on HVSC
Plus cable only. Using the following guide, check the cable first prior to performing the
termination to ensure the use of the correct upper termination kit.
HVSC Plus cable has an outer diameter of approximately 35 mm and has an aluminium
stranded centre conductor and copper tape screen (which can be easily seen from the
end of the cable).
This Termination Kit will not work with any other cable.
Tools and parts required for the completion of the HVSC Plus Upper Termination include:
∆
Compression or mechanical crimping tool (for 50 mm² crimp lug)
∆
Sharp knife
∆
Scissors
∆
#2 Phillips head screwdriver
∆
Shifting spanner (or 17 mm spanner/socket)
∆
Heat gun or gas torch (LPG)
∆
Tape measure (metric)
∆
Combination pliers/cutters
∆
Mast base assembly (supplied with the Guardian Plus Terminal)
Upper Termination Kit consists of:
∆
Instructions
∆
1 x Roll of semi-conductive tape
∆
1 x 50 mm² crimp lug
∆
2 Heatshrink tubes (1 x 1200 mm & 1 x 600 mm length)
www.lpi.com.au
LIGHTNING PROTECTION INTERNATIONAL PTY LTD
27
Advertisement
Table of Contents
