Table of Contents
Advertisement
5. Straighten the cable back to the Black PVC Outer Sheath as much as possible then
crimp the Inner Copper Conductors into the supplied 50mm
compression or mechanical crimping tool. (Figure 25)
Figure 25.
6. Connect the crimp lug to the Guardian CAT Terminal Base Assembly using the bolt and
washers as supplied with the assembly. Ensure the connection is aligned correctly
and tightly secured using a 14mm spanner, socket or shifting spanner. (Figure 26)
Figure 26.
7. Use a marker or pen to mark 30cm intervals on the White XLPE Insulation between the
end of the Outer Copper Screen Wires and the Crimp - this will act as a guide to wrapping
the semiconductive tape towards the Crimp in a coarse spiral. (Figure 27)
Figure 27.
30
Guardian Install Manual V12.indd 32
crimp lug using a suitable
2
Document 36 II Guardian
Version 1.02
© Copyright 2008 LPI
22/9/08 4:25:26 PM
Advertisement
Table of Contents
