DERRICK HYPERPOOL SHAKER Maintenance & Operation Manual page 79

13 - Using a soft absorbent cloth, remove
excess lubricant from interior of bearing
housing and inner bearing race. Do not
use compressed air for cleaning as this
may drive contaminants into motor.
Bearing Installation
1 - Remove inner bearing race from
assembled bearing and bearing mount
supplied with bearing replacement kit. Be
careful to avoid contaminating
components.
15 Jun 12
14 - Using a torch with a diffused flame,
gently heat inner bearing race for no more
than 10 seconds to approximately 200°-
230°F (93°-110°C) to facilitate removal.
15 - Carefully remove and discard heated
inner bearing race from motor shaft. Using
a soft absorbent cloth, remove excess
lubricant from interior of bearing housing.
Do not use compressed air for cleaning as
this may drive contaminants into motor.
2 - Wipe excess lubricant from inner
bearing race, and position on motor shaft
with collar toward motor body. Using a
these bearing heater or a torch with a diffused
flame, heat
approximately 200°-230° F (93°-110° C).
SGX VIBRATOR MOTOR
inner bearing race to
7-21
HyperPoolShaker