Maintenance; Jun; General; Routine Maintenance - DERRICK HYPERPOOL SHAKER Maintenance & Operation Manual

GENERAL

This section contains routine maintenance, inspection, screen panel replacement, and parts
replacement for the HyperPool shaker. Routine maintenance will ensure maximum life and
trouble-free operation. While the maintenance schedule presented in this section is flexible,
modifications should be based on experience with operating the equipment at your facilities. A
maintenance log (see Section 9) should be kept to help establish a routine maintenance
schedule, as well as to monitor and adjust the schedule as necessary throughout the equipment's
life.
When establishing a maintenance schedule, consider duty cycle, ambient temperature, and
operating environment.

ROUTINE MAINTENANCE

Routine maintenance consists of overall inspection and cleaning. Following are the recommended
routine maintenance procedures.
Inspect feed connection to feeder, desander, or desilter for leaks, and
tighten connection as required.
Inspect discharge duct connection on side of hopper for leaks. Tighten
connection and/or add silicone sealant to prevent leakage.
Inspect cover on unused hopper discharge connection for leaks. Tighten
connection and/or add silicone sealant to prevent leakage.
Wash off accumulated process material from screen frame, interior of
hopper and AWD angle adjustment components. Excess process
material in these areas may impede angle adjustment of screen frame
and can reduce screen frame vibration if the frame bottoms out on the
buildup.
Check for and remove any accumulation of process material or other
obstruction in feeder interior. Feeder blockage may cause excessive
splashing and uneven distribution of slurry onto the screen bed.

15 Jun 12

SECTION 5 - MAINTENANCE
ROUTINE MAINTENANCE
Action Frequency
Each shift
Each shift
Each shift
Each shift
Weekly
5-1
HyperPoolShaker