Installation Sequence; Storage; Site Preparation And Clearance Requirements - DERRICK HYPERPOOL SHAKER Maintenance & Operation Manual

Sgx motor
Table of Contents

Advertisement

INSTALLATION

INSTALLATION SEQUENCE

Following is the sequence of steps for installing the HyperPool shaker. The sequence presented
may vary depending on selected options, the user's facilities, and previous experience with this
type of equipment.
1. Read and understand all safety information in Section 2 before installing and operating this
equipment.
2. Install desilter and desander, if required.
3. Position and level equipment at installation site.
4. Remove shipping brackets.
5. Connect feed line to desilter or desander (if installed) or to feeder.
6. Connect discharge duct to hopper.
7. Connect electric power supply to the shaker.
8. Install screen panels.
9. Refer to Section 4 for startup and operating instructions.

STORAGE

If the machine will not be installed immediately, it should be covered with a tarpaulin (tarp). If unit
is stored outdoors, use a UV-resistant tarp, or UV-resistant shrink-wrap. Install vents when using
shrink-wrap.

SITE PREPARATION AND CLEARANCE REQUIREMENTS

Prior to placement of equipment, verify that electricity and water are available at the installation
site and that feed and discharge lines are provided. Also ensure that clearances around the
equipment are adequate. Prepare the installation site as follows:
1. Provide adequate clearances on all four sides of machine and/or multi-machine installations.
Figure 3-1 shows minimum clearances on all sides of machine(s).
2. Confirm that mounting structure is properly positioned and adequate to support the weight of
the shaker.
3. Check that feed and discharge lines are available and properly sized and located for
connecting to desiliter and desander.
4. Check that discharge duct size and location will match the equipment drainage cutout.
5. Verify that electric power supply at the site agrees with electric power requirements of the
equipment.
3-2
HyperPoolShaker
15 Jun 12

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the HYPERPOOL SHAKER and is the answer not in the manual?

Table of Contents

Save PDF