Laser Unit - Sharp MX-C400P Operation Manual

8
9
Holes to be cleaned
There are a total of 4 holes to be cleaned in the laser unit.
If the cleaner becomes dirty during cleaning, replace with a new cleaner. For the procedure for replacing the cleaner,
see steps 5 to 7.
10
Clean the laser unit.
(1) Point the cleaner down and slowly insert
(A)
(2) Insert the cleaning tool all the way into the
(3) Repeat step (2) two or three times and then
Repeat step 8 to clean all holes in the

laser unit.

Replace the cleaning tool.
1-71
BEFORE USING THE MACHINE
the tool into the hole that you wish to clean.
The parts of the writing unit that require cleaning are
indicated by labels similar to (A).
hole and then pull it back out.
Pull the cleaning tool out until you feel the tip of the tool
leave the cleaning surface of the laser unit.
remove the cleaning tool.