Turning The Power On And Off - Sharp MX-C400P Operation Manual

TURNING THE POWER ON AND OFF

The machine has two power switches. One is the main power switch on the left side of the machine, and the other is the
[POWER] key ( ) on the right side of the operation panel.
Main power switch
When the main power switch is switched on, the main
power indicator on the operation panel lights up.
"On" position
"Off" position
Turning on the power
(1) Switch the main power switch to the "on"
position.
(2) Press the [POWER] key (
power.
• When turning off the power, be sure to press the [POWER] key (
switch off the main power switch. In the event that the main power is suddenly interrupted due to a power failure or other
reason, turn the machine power back on and then turn it off in the correct order.
If the machine is left for a long time with the main power having been turned off prior to the [POWER] key (
noises, degraded image quality, and other problems may result.
• Before switching off the main power switch, make sure that the display is off and the DATA indicator for printing is not lit or
blinking on the operation panel.
Switching off the main power switch or removing the power cord from the outlet while any of the indicators are lit or blinking
may cause failure, such as damage to the hard drive or loss of data.
• Switch off both the [POWER] key (
failure, if there is a bad thunderstorm nearby, or when you are moving the machine.
Restarting the machine
In order for some settings to take effect, the machine must be restarted.
If a message in the display prompts you to restart the machine, press the [POWER] key (
then press the key again to turn the power back on.
In some states of the machine, pressing the [POWER] key (
use the main power switch to switch the power off and then on.
) to turn on the
) and the main power switch and unplug the power cord if you suspect a machine
1-13
BEFORE USING THE MACHINE
[POWER] key
BACK
PRINT
JOB
STATUS
SYSTEM
SETTINGS
LOGOUT
Turning off the power
(1) Press the [POWER] key (
power.
(2) Make sure that the display is off.
(3) Switch the main power switch to the "off"
position.
) on the operation panel, then wait 20 seconds and
) to restart will not make the settings take effect. In this case,
Main power indicator
OK READY
DATA
[POWER] key
) to turn off the
), abnormal
) to turn off the power and