Ring/Network Coupling
Note: The following settings are required for the coupling ports (you
select the Basic Settings:Port Configuration dialog):
See table on
Note: If VLANs are configured, set the coupling and partner coupling
ports' VLAN configuration as follows:
– in the dialog Switching:VLAN:Port Port VLAN ID 1 and „Ingress
Filtering" deactivated
– in the dialog Switching:VLAN:Static VLAN-Membership U
(Untagged)
Select "Two-Switch coupling with control line" by means of the dialog
button with the same graphic as below
3
2
STAND-BY
Figure 24: Two-Switch coupling with control line
1: Coupling port
2: Partner coupling port
3: Control line
The following settings apply to the switch displayed in blue in the
selected graphic.
Select the coupling port
With "Coupling port" you specify at which port you are connecting
the network segments:
You will find the port assignment for the redundant coupling in
table 10.
For a device with DIP switches, you switch the stand-by switch to ON
or deactivate the DIP switches. You connect the redundant line to
the coupling port.
Select the control port
With "Control port" you specify at which port you are connecting the
control line.
UM Redundancy Configuration L2E
Release 7.1 12/2011
17 "Port settings for ring
1
ON
(see fig.
(see fig. 23)
4.2 Preparing a Ring/Network
ports".
(see fig.
24).
23).
Coupling
53