Hirschmann RS20 User Manual page 37

Ring/Network Coupling
The following tables show the selection options and default settings for the
ports used in the Ring/Network coupling.
Device Partner coupling port
RS2-./. Not possible
RS2-16M All ports (default setting: port 2)
RS20, RS30, All ports (default setting: port 1.3)
RS40
OCTOPUS All ports (default setting: port 1.3)
MICE All ports (default setting: port 1.3)
PowerMICE All ports (default setting: port 1.3)
MS20 All ports (default setting: port 1.3)
MS30 All ports (default setting: port 2.3)
RSR20/30 All ports (default setting: port 1.3)
MACH 100 All ports (default setting: port 2.3)
MACH 1000 All ports (default setting: port 1.3)
MACH 3000 All ports
MACH 4000 All ports (default setting: port 1.3)
Table 8: Port assignment for one-Switch coupling
Note: Configure the partner coupling port and the ring redundancy ports
on different ports.
 Select the coupling port
With "Coupling port" you specify at which port you are connecting
the network segments:
You will find the port assignment for the redundant coupling in
table 8.
Note: Configure the coupling port and the redundancy ring ports on
different ports.
 Activate the function in the "Operation" frame
 Now connect the redundant line.
The displays in the "Select port" frame mean:
– "Port mode": The port is either active or in stand-by mode.
– "Port state": The port is either connected or not connected.
UM Redundancy Configuration L2E
Release 7.1 12/2011
4.2 Preparing a Ring/Network
Coupling port
Not possible
All ports (default setting: port 1)
All ports (default setting: port 1.4)
All ports (default setting: port 1.4)
All ports (default setting: port 1.4)
All ports (default setting: port 1.4)
All ports (default setting: port 1.4)
All ports (default setting: port 2.4)
All ports (default setting: port 1.4)
All ports (default setting: port 2.4)
All ports (default setting: port 1.4)
All ports
All ports (default setting: port 1.4)
(see fig. 10).
Coupling
(see fig. 10)
37