Hirschmann RS20 User Manual page 19

Ring Redundancy
enable
configure
hiper-ring mode ring-manager Select the HIPER-Ring ring redundancy and
Switch's HIPER Ring mode set to ring-manager
hiper-ring port primary 1/1
HIPER Ring primary port set to 1/1
hiper-ring port secondary 1/2 Define port 2 in module 1 as ring port 2.
HIPER Ring secondary port set to 1/2
exit
show hiper-ring
HIPER Ring Mode of the Switch.................. ring-manager
configuration determined by.................. management
HIPER Ring Primary Port of the Switch.......... 1/1, state active
HIPER Ring Secondary Port of the Switch........ 1/2, state active
HIPER Ring Redundancy Manager State............ active
HIPER Ring Redundancy State (red. exists).. no (rm is active)
HIPER Ring Setup Info (Config. failure)........ no error
HIPER Ring Recovery Delay...................... 500ms
 Now proceed in the same way for the other two devices.
Note: If you have configured VLANS, note the VLAN configuration of the ring
ports.
In the configuration of the HIPER-Ring, you select for the ring ports
– VLAN ID 1 and "Ingress Filtering" disabled in the port table and
– VLAN membership U in the static VLAN table.
Note: Deactivate the Spanning Tree protocol for the ports connected to the
HIPER-Ring, because Spanning Tree and Ring Redundancy affect each
other.
UM Redundancy Configuration L2E
Release 7.1 12/2011
2.1 Example of a HIPER-Ring
Switch to the privileged EXEC mode.
Switch to the Configuration mode.
define the device as ring manager.
Define port 1 in module 1 as ring port 1.
Switch to the privileged EXEC mode.
Display the HIPER-Ring parameters.
19