Ce Conformity And Labelling; Warnings - Danfoss AHF005 Design Manual

Safety and Conformity
Equipment containing electrical components may
not be disposed of together with domestic waste.
It must be separately collected with electrical and
electronic waste according to local and currently
valid legislation.
MCC 101/102
Design Guide

2.1.3 CE Conformity and Labelling

What is CE Conformity and Labelling?
The purpose of CE labelling is to avoid technical trade
obstacles within EFTA and the EU. The EU has introduced the
CE label as a simple way of showing whether a product
complies with the relevant EU directives. The CE label says
nothing about the specifications or quality of the product.
The low-voltage directive (73/23/EEC)
Frequency converters must be CE labelled in accordance with
the low-voltage directive of January 1, 1997. The directive
applies to all electrical equipment and appliances used in the
50 - 1000 V AC and the 75 - 1500 V DC voltage ranges. Danfoss
CE-labels in accordance with the directive and issues a
declaration of conformity upon request.

2.1.4 Warnings

WARNING
Improper installation of the filter or the frequency
converter may cause equipment failure, serious injury or
death. Follow this Design Guide and install according to
National and Local Electrical Codes.
WARNING
Never work on a filter in operation. Touching the electri-
cal parts may be fatal - even after the equipment has
been disconnected from the drive or motor.
WARNING
Before disconnecting the filter, wait at least the voltage
discharge time stated in the Design Guide for the
corresponding frequency converter to avoid electrical
shock hazard.
AHF005/010 Design Guide
When in use the filter surface temperature rises. DO NOT
touch filter during operation.
To prevent resonances in the DC-link, it is recommended
to disable the dynamic DC-link compensation by setting
par. 14-51 to OFF.Se chapter Ho to Programme the
Frequency Converter.
Temperature contactor must be used to prevent
damage of the filter caused by over temperature. An
immediate stop or a controlled ramp down within 30
seconds has to be performed to prevent filter damage.
NOTE
Never attempt to repair a defect filter.
NOTE
The filters represented in this Design Guide are specially
designed and tested for operation with Danfoss
frequency converters (FC 102/202/301 and 302) Danfoss
takes no responsibility for the use of the filters with third
party frequency converters.
Non - authorized removal of required cover, inappropri-
ate use, incorrect installation or operation, creates the
risk of severe injury to persons or damage to material
assets.
All operations concerning transport, installation and
commissioning as well as maintenance must be carried
out by qualified, skilled personnel (IEC 60364 and
CENELEC HD 384 or IEC 60364 and IEC-Report 664 or DIN
VDE 0110. National regulations for the prevention of
accidents must be observed).
NOTE
According to this basic safety information qualified
skilled personnel are persons who are familiar with the
assembly, commissioning and operation of the product
and who have the qualifications necessary for their
occupation .
®
MG.80.C3.02 - VLT is a registered Danfoss trademark
CAUTION
CAUTION
CAUTION
WARNING
CAUTION
2 2
5