Panel Basics - ABB Eurofire EN54 User And Engineers Instructions

Panel Basics

The fire control panel is operated by the 6 buttons which are mounted below the LCD. In order to gain access to the
fire panel functions, it is necessary to enter the 4 digit user code – this is to prevent unauthorised access.
In order to enter the user code, the password screen must be activated. This is done by:-
- Pressing any of buttons 1, 2, 3 or 6.
PLEASE ENTER VALID
The number represented by each button is displayed on the fascia above the button.
- Enter the user code (Initially this is factory set to 3545)
If the correct code is entered, the display will now show:-
11 Evacuate
→12 ------EXIT------
13 Top of engineers
Silence Up
The bottom line of the LCD shows the functions available with the buttons on which they are directly above.
Note, that buttons 1 & 2 have RESET and SILENCE BUZZER permanently assigned to them.
Button 1 – RESET - Returns the Fire Alarm System to a normal clear condition – Resetting fire alarm detectors,
silencing all sounders and resetting other devices connected to the control panel.
Button 2 - SILENCE - Causes the internal buzzer during a Fire or Fault condition to stop sounding. Any
BUZZER subsequent Fire or Fault condition will cause the buzzer to resound.
Button 3 - SILENCE - Is used to turn off the external alarm sounders after a fire activation. The control
ALARMS panel will however continue to indicate a fire condition and the internal buzzer will
continue to bleep. Any subsequent Fire activation will resound the external alarm
sounders.
When the alarm sounders have been 'silenced', the LCD option will show 'Resound'.
Pressing Button 3 now, the external sounders will be turned back on and the LCD
option reverts back to 'Silence'.
Button 4 - Up - Will take you up through the menu system
Button 5 - Dwn - Will take you down through the menu system. Note with USER access you CANNOT
enter the Engineers menu.
Button 6 - OK - Is used to enter the menu choice which is highlighted on the LCD.
For example, pressing button 6 on the LCD shown above, 'EXIT' being the highlighted
option - would take you out of the menu system.
PASSWORD
- - - -
^
Dwn Ok
5