Gas Connection - Fisher & Paykel OR90 Series Installation Manual

Gas supply
The connection must be performed by an authorised person according to the relevant standards.

 This appliance is suitable for use with Natural Gas or LPG. The gas cooker is shipped from the factory set and
adjusted for Natural Gas. It can be converted for use with LPG following the instructions in this manual.
If the Natural gas/LPG conversion kit is not supplied with the appliance this kit can be purchased by contacting

the After-Sales Service.

If connecting the gas with a flexible hose
The ambient temperature of the hose must not exceed 70°C. These hoses must be manufactured in accordance

with BSE669 part 1 or EN 14800 and be of the correct construction for the type of gas being used.
Never use a hose designed for natural gas for supplying LPG gas (LPG hoses either have a red band or stripe on

the rubber outer coating of the hose.)
The hose should not be crushed or trapped or be in contact with sharp or abrasive edges.

Installation to Natural Gas
Installation to Natural Gas must conform to the Code of Practice, etc.

The supply pressure for Natural Gas is 20 mbar.

 The installation must conform to the relevant British/European Standards.
Installation to LP Gas
When operating on Butane gas a supply pressure of 28-30 mbar is required.

 When using Propane gas a supply pressure of 37 mbar is required.
The installation must conform to the relevant British/European Standards.

Warning: Only a suitably qualified and registered installer, also with technical knowledge of electricity should

install the appliance.
 They should observe the Regulations and Codes of Practice governing such installation of gas appliances.
 Note: It is recommended that the gas connection to the appliance is installed with a flexible hose connecting tube
made to BS669 or EN 14800.
16
!7

GAS CONNECTION

NG LPG
Manifold
(Gas inlet pipe)
Manifold male
pipe fitting
Fibre washer
Connector
1/2 G cylindrical
(ISO 228-1) male
1/2" G cylindrical
(ISO 228-1) female
1/2" BSP female