Installing The Anti-Tip Bracket - Fisher & Paykel OR90 Series Installation Manual

IMPORTANT!
 To restrain the cooker and prevent it tipping accidentally secure
the cooker to the wall using the supplied anti-tip bracket. If
installing the cooker above a plinth (without fitting the adjustable
feet) revise the installation dimensions for the anti-tip bracket
accordingly, considering that the feet have the following
measurements: min 85mm - max 133mm.
 Before drilling and holes or inserting any screws into the floor or
wall check that you will not damage any wiring or pipes.
When sliding the cooker back into place take care not to trap the

power supply cable or gas connection hose in the anti-tip bracket.
To fit the anti-tip bracket
1 Loosely fix the anti-tip bracket to the wall using the supplied screws.
Drill two 8mm diameter holes in the wall and insert the supplied

plastic sleeve anchors before inserting the screws.
2 Slide the cooker into place and adjust the height of the bracket so
that it will align with the slot on the back of the cooker.
3 Tighten the screws to fix the anti-tilt bracket in place.
4 Push the cooker back into place so that the bracket is fully inserted
into the slot on the back of the cooker.
!4

INSTALLING THE ANTI-TIP BRACKET

anti-tip bracket
bracket slot at back
of the cooker
Dotted line showing the position
of the cooker when installed
40mm
min. 167mm
max. 217mm
13