Floor Mounting For Sizes 1 And 2 - Siemens SENTRON 3KC0 Manual

5.3.3

Floor mounting for sizes 1 and 2

Overview
A 3KC9120-1 assembly kit for floor mounting is needed for floor mounting. You can find
more information in chapter Component overview for sizes 1 and 2 (Page 56).
Note
The assembly kit for floor mounting including the mounting bracket are not included in the
scope of supply.
Procedure
Note
Once you have inserted the mounting bracket into the recess of the side panel cover, it is not
possible to remove it again.
1. Push the four mounting brackets into the recesses on the side panel cover.
2. Push the two mounting plates on the underside on the left and right into the DIN rail guide
until they engage. Ensure that the openings for the bolts on the mounting brackets and on
the mounting plates are aligned with each other.
3. Mount the transfer switching equipment in the desired position using four bolts.
3KC0 manual transfer switching equipment
Manual, 09/2018, L1V30368969105-01
5.3 Mounting the 3KC0 transfer switching equipment
Mounting
27