Siemens SINAMICS G120D Getting Started page 6

Table of contents
Objective of these instructions
This Getting Started describes how you install an inverter and commission and operate it
using the IOP operator panel.
The functions and properties of the IOP are described in detail in the "SINAMICS IOP"
operating instructions and are only explained here to an extent that is necessary to
understand the described functions.
Additional information on SINAMICS G120
All manuals for the inverter can be downloaded from the Internet and are additionally
available on DVD. See also Section: Further information (Page 63).
What is the meaning of the symbols in the manual?
Firmware upgrade and downgrade
Options for upgrading and downgrading the firmware can be found on the Internet at
http://support.automation.siemens.com/WW/view/de/67364620
(http://support.automation.siemens.com/WW/news/en/67364620).
Transferring license terms of the OSS code to a PC
Procedure
To transfer the OSS license terms from the inverter to a PC, proceed as follows:
1. Switch off the inverter power supply.
2. Insert an empty memory card into the card slot of the inverter. Also see Section:Overview
of the interfaces (Page 22)
3. Switch on the inverter power supply.
4. When you have switched on the power supply, wait 30 seconds.
During this time, the inverter writes the "Read_OSS.ZIP" file onto the memory card.
5. Switch off the inverter power supply.
6. Remove the card from the inverter.
7. Use a card reader and load the file to a PC.
You have then transferred the OSS license terms from the inverter to a PC.
6
An operating instruction starts here.
This concludes the operating instruction.
SINAMICS G120D converter with control units CU240D-2 and CU250D-2
Getting Started, 04/12014, FW V4.7, A5E34262374B AA