Siemens SINAMICS G120D Getting Started page 51

12. Select to run or disable Motor Data Identification
13. Select either zero pulse on no zero pulse for the
14. Enter the correct pulses per revolution for the encoder.
15. Select the macro that is suitable for your application.
16. Set the Minimum Speed at which the attached motor
17. Set the Ramp Up time in seconds.
SINAMICS G120D converter with control units CU240D-2 and CU250D-2
Getting Started, 04/12014, FW V4.7, A5E34262374B AA
function.
This function, if active, will not start until the first run
command is given to the Inverter.
attached encoder.
If no encoder is fitted to the motor, the option will not be
displayed.
This information is normally printed on the casing of the
encoder.
Once selected all inputs, outputs, command sources
and setpoints will be automatically configured by the
software.
For further information see the section that details the
precise settings for each macro. Please see installation
section of this manual.
should run.
This is the time the Inverter/motor system will take from
being given the run command, to reaching the selected
motor speed.
Commissioning
4.2 Commissioning with the IOP
51