Siemens SINAMICS G120D Getting Started page 40

Installation
3.7 Default settings of inputs and outputs
Default setting 9: Motorized
potentiometer (MOP)
Fieldbus interface is not active.
Default setting 14: Switch over between fieldbus and motorized potentiometer
PROFIdrive telegram 20
Default setting 25: Communication via fieldbus with safety
function; transfer of the DI 0 to DI 3 and all DOs to fieldbus
PROFIdrive telegram 352 + PZD7
Default settings of inputs and outputs (CU250D-2)
Default setting 26: Basic positioner via inputs and outputs;
factory settings
The fieldbus interface is not active.
40
Default setting 12: Two-wire control
with method 1
Fieldbus interface is not active.
(MOP) using DI 3
Fieldbus interface is not active.
Fieldbus interface is not active.
PROFIdrive telegram 352 + PZD7
Default setting 27: Basic positioner via fieldbus
PROFIdrive telegram 111
SINAMICS G120D converter with control units CU240D-2 and CU250D-2
Getting Started, 04/12014, FW V4.7, A5E34262374B AA
Default setting 13: Setpoint via analog
input with safety function
Default setting 24: Communication via
fieldbus; transfer of all DIs and DOs to
fieldbus