Panasonic SDR-H250GC Operating Instructions Manual page 200

Sd card/hard disk video camera
Hide thumbs Also See for SDR-H250GC:
Table of Contents

Advertisement

LSQT1212_GC(EN).book 200 ページ 2007年2月15日 木曜日 午前10時13分
Others
Problem
The remote control does
not function.
A function indication
such as the remaining
time indication or the
elapsed time indication is
not shown.
Recording does not start
although power is
supplied to this unit.
Recording starts but
stops immediately.
The playback picture
breaks up for a moment.
The unit arbitrarily stops
recording.
The operation arbitrarily
stops.
Recording stops
suddenly during motion
picture recording on a
card.
200
LSQT1212
≥ Has the button-type battery of the remote control run out?
# Replace it with a new button-type battery. (l 115)
≥ If you set [SETUP]>[DISPLAY]>[OFF], indications other than
warnings and date indications disappear.
≥ Has the SD card's write protect switch been set to LOCK?
# No recording is possible while the write protect switch is set to
LOCK. (l 118)
≥ Is the memory of the HDD or card full?
# If the HDD or card has no more available memory, free up some
memory by deleting unnecessary scenes (l 162, 167) or use a
new card.
≥ Is the unit set to the video recording mode or picture recording
mode?
# No recording is possible unless the mode dial is at
≥ Is the card slot cover open?
# If the cover is open, this unit may not operate normally. Close the
card slot cover.
≥ The unit is hot. Follow the messages on the display.
# To use the unit again, turn the unit off and leave it for a while.
≥ Is the AGS function activated?
# Record in the normal horizontal position or set [AGS] to [OFF].
(l 136)
≥ Can the SD card be used for motion picture recording?
# Use an SD card that can be used for motion picture recording.
(l 118)
≥ The drop detection function has activated to protect the HDD.
# Do not drop or shake this unit while operating it.
≥ When using an SD card on which data has been written many
times and the data writing speed has reduced, the recording
may suddenly stop during motion picture recording.
# Use a card recommended as suitable for motion picture
recording. (l 118)
If the recording stops even when a suitable SD card is used,
back up the data on the card to a computer, etc. and then format
the card. (l 171)
Check points
or
.

Advertisement

Chapters

Table of Contents
loading

This manual is also suitable for:

Sdr-h21gcSdr-h20gc

Table of Contents