Panasonic SDR-H250GC Operating Instructions Manual page 195

LSQT1212_GC(EN).book 195 ページ ２００７年２月１５日 木曜日 午前１０時１３分
CHANGE TO MANUAL
MODE.
CANCEL NIGHT VIEW
MODE.
TURN OFF THE VIDEO
LIGHT.
OPERATION FAILED.
EXCESSIVE SHOCK
DETECTED. PLEASE TRY
AGAIN AFTER A WHILE.
INTERNAL TEMPERATURE
TOO HIGH. PLEASE TURN
UNIT OFF AND WAIT A
WHILE.
OPERATION STOPPED.
TEMPERATURE TOO LOW.
PUSH THE RESET
SWITCH.
DISCONNECT USB
CABLE.
CANNOT OPERATE WHILE
USB CONNECTED.
About recovery
It is possible that the system cannot complete writing of a file normally when, for example, power is
turned off for some reason during recording or editing.
If faulty management information is found when the HDD or a card is accessed, one of the following
messages may appear. Be sure to follow the messages. (Repairing may take time depending on the
error.)
HDD ERROR DETECTED. NOW REPAIRING DATA.
CARD ERROR DETECTED. NOW REPAIRING DATA.
≥ When you repair the data, use a battery with sufficient battery power or the AC adaptor. Even if the
power is turned off without repairing the data, you can repair the data when you turn the power on
again.
≥ Depending on the condition of the data, it may not be possible to completely repair the data.
≥ Do not repair a card that has been recorded on another device. This may cause the loss of data or
the card.
You are attempting to use a function that cannot be used
simultaneously.
The unit has detected that it is being dropped so the operation has
stopped.
The internal temperature of this unit is high so it cannot be operated.
Turn off the power, wait until the temperature falls and then turn on
the power again.
The internal temperature of this unit is extremely low so it cannot be
operated.
If "Please Wait." appears after this message, wait a while without
turning the unit off. It may take time until the unit can be used.
An irregularity in the unit has been detected. Remove the SD card
then press the RESET button to restart the unit. (l 202)
The unit cannot correctly establish the connection to the computer
or printer. Disconnect and reconnect the USB cable and then select
the desired USB function again.
The unit's power cannot be turned off when the unit is connected to
the computer.
Others
195
LSQT1212