Locking Still Picture Files - Panasonic SDR-H250GC Operating Instructions Manual

LSQT1212_GC(EN).book 168 ページ ２００７年２月１５日 木曜日 午前１０時１３分
Editing
1
Press the button in the
thumbnail display.
2
Select [ALL] or [SELECT] and
press the joystick.
≥ When [ALL] is selected, all files on the medium
except the locked files will be erased. Proceed
to step 5.
3
(Only when [SELECT] is selected in step 2)
Select the file to be deleted, then
press the joystick.
The selected file is encircled by a red frame.
≥ When the joystick is pressed again, the
selected file will be cancelled.
≥ Up to 50 files can be set in succession.
4
(Only when [SELECT] is selected in step 2)
Press the button.
5
When the confirmation message
appears, select [YES], then press
the joystick.
(Only when [SELECT] is selected in step 2)
To continue deleting other files
Repeat steps 3-5.
To cancel deleting halfway
Press the MENU button.
≥ Files are deleted from the last file on the
thumbnail display. The files that have already
168
LSQT1212
been deleted when the deletion is cancelled
cannot be restored.
To complete editing
Press the MENU button.
∫ Deleting still picture files recorded on an
SD card by other products
A still picture file (other than JPEG) that cannot
be played back on this unit may be erased.
≥ You can also delete files by pressing the
MENU button, selecting [DELETE] and then
selecting [ALL] or [SELECT].
≥ In case of [ALL], the deletion may take time if
there are many files.
≥ Do not turn off this unit while deleting.
≥ When you delete files, use a battery with
sufficient battery power or use the AC adaptor.
≥ Do not open the card slot cover while deleting
files recorded on an SD card. The deletion will
stop.
≥ If files conforming to DCF standard are
deleted, all the data related to the files will be
deleted.

Locking still picture files

This is for preventing still picture files
from being deleted by mistake.
Still picture files can be locked so that they are
not deleted by mistake. (However, please be
aware that if a medium is formatted, then all the
data on the medium will be erased.)
¬ Rotate the mode dial to select
¬ Select [HDD] or [SD CARD] in [MEDIA
SELECT].
[HDD] [SD]
.