Regulatory And Compliance Notices; Warranty Statement - Keiser M Series Assembly And Operation Manual

Hide thumbs Also See for M Series:
Table of Contents

Advertisement

M3i | M3 TOTAL BODY TRAINER

REGULATORY AND COMPLIANCE NOTICES

COMPLIANCE
This device complies with Industry Canada Licence-Exempt
RSS standard(s). Operation is subject to the following two
conditions: (1) this device may not cause interference, and
(2) this device must accept any interference, including
interference that may cause undesired operation of the
device.
Le present appareil est conforme aux CNR d'industrie
Canada applicables aux appareils radio exempts de
licence. L'exploitation est autorisee aux deux conditions
suivantes: (1) l'appareil ne doit pas produire de brouillage,
et (2) l'utilisateur de l'appareil doit accepter tout brouillage
radioelectrique subi, meme si le brouillage est susceptible
d'en compromettre le fonctionnement.
REGULATORY NOTICE
NOTE: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide
California Proposition 65 Warning: This product contains chemicals known in the State of California to cause cancer,
birth defects, and/or other reproductive harm.
BLUETOOTH
word mark and logos are registered trademarks of Bluetooth SIG, Inc.; LPS 3
®
smart
Brands, an Illinois Tool Works Company; WD-40
trademark of Hydrotex, Partners, Ltd.; MEGUIAR'S

WARRANTY STATEMENT

For information about Keiser's product warranty and thereto related information, refer to keiser.com/support/warranty.
®
Long-Term Corrosion Inhibitor is the registered trademark of WD-40 Company; HYDROTEX
is the registered trademark of Meguiar's, Inc.; and POLAR
®
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is
no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following
measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and
receiver.
— Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician
for help.
Rust Inhibitor is the registered trademark of ITW Pro
®
®
23
®
is the registered
is the registered trademark of Electro Oy.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

M3iM3

Table of Contents