Mounting The Fan Blades - Fanimation Brewmaster FP10 Series Owner's Manual

CAUTION
Do not connect fan blades until the fan is completely
installed. Hanging fan with blades connected may result
in damage to the fan blades.
Natural Palm Leaf, Woven Bamboo, Woven Wicker
Blades
1. Lay side "A" of the blade holder on a fl at surface with
the inside of the blade holder facing up. This is the side
with the threaded posts and pitched foot (Figure 1).
2. Position the palm leaf, or the woven bamboo or wicker
blade over the blade holder with the threaded posts
showing. Make sure the bottom edge of the blade is fully
seated against the blade holder.
3. Place side "B" of the blade holder on top of the blade,
positioning the holes over the threaded posts.
4. With a Phillips screwdriver, thread both screws into the
posts but do not fully tighten.
5. Prior to fi nal tightening, position the center line of the
blade holder with the center of the end of the blade.
6. Tighten both screws to secure the blade (Figure 1).
Standard Reversible Wooden Blades
1. Mount the wooden blades on the blade holder with
three screws and three fi ber washers .
2. Then mount the assembled blade/blade holder onto
the fl ywheel, secure with fl ywheel screws.
(Figure 2)
NOTE: Optional Wood Blade Holders (BH20 series) and
B4000 wood blades are available for this assembly. Not
for Damp Location usage.

Mounting the Fan Blades

11
Side B
Fan Blade
Figure 1
Reversible
Wooden Blade
Palm Leaf, Woven Bamboo,
or Wicker Blade
NOTE: Blade detail omitted for clarity.
Figure 2
Side A