Scan A Memory Bank - AOR AR-DV10 Operating Manual

Hide thumbs Also See for AR-DV10:

Operating manual (64 pages)

Table Of Contents

Table of Contents

FREQ:

Use the keypad to enter the frequency in MHz, followed by [ENT].

MODE:

Rotate the dial selector knob to select the desired demodulation mode, and

press [ENT].

IFBW:

Rotate the dial selector knob to select the desired IF bandwidth, and press

[ENT].

PASS:

Rotate the dial selector knob to toggle the frequency pass ON or OFF, and

press [ENT]. If set to ON, this memory channel will be ignored when its memory

bank is scanned.

Input a name as described in chapter 10.3 "INPUT CHARACTERS &

SYMBOLS".

PROTECT: Rotate the dial selector knob to toggle the protect ON or OFF, and press [ENT].

If set to ON, this memory channel cannot be erased.

(on page 2/2)

SQL N/L:

Rotate the dial selector knob to chose between LEVEL, NOISE or AUTO

squelch.

SQL TYPE: Rotate the dial selector knob to chose between CTCSS, DCS, reverse tone and

OFF.

CTCSS:

Rotate the dial selector knob to set the CTCSS tone frequency manually, or in

automatic discovery mode (SRCH), or OFF.

: Rotate the dial selector knob to set the DCS tone code manually, or in

DCS CODE

automatic discovery mode (SRCH), or OFF.

AGC:

Rotate the dial selector knob to set automatic gain control to FAST, MID, SLOW

or RF-G.

Set the offset frequency function as described in chapter 10.8 "OFFSET

OFFSET F.:

RECEPTION".

V.SCR:

Set the voice descrambler function as described in chapter 10.6 "ANALOG

VOICE DESCRAMBLER"

Finally save all your settings: Use the [▶] button to go to the last line [MEM CH PARAM SET]

and press [ENT].

7.2.