Create A Group Of Linked Search Banks - AOR AR-DV10 Operating Manual

9.4.

CREATE A GROUP OF LINKED SEARCH BANKS

There are 10 search groups (numbered 0 to 9) that you can set up individually to search a
group of linked search banks. Each search group can be setup with its own squelch
behavior as follows:
 Delay time: Time between signal interruption and squelch closing, for search to
resume.
 Free time: Time after which search will resume, no matter if the signal was interrupted
or not.
Auto store: The first 50 busy frequencies located during search are automatically

saved in memory bank 39, for later review and scanning.
How to create a search group:
1. Press [MENU], use the [▶] button to select [SRCH]
and press [ENT].
2. Use the [▶] button to select [GRP EDIT] and press
[ENT] twice.
3. Enter the search group number you would like to
create, with the keypad.
This illustration shows an example of search group 0
and all search bank numbers from 00 to 39 which
can be linked, providing of course they have already
been programmed.
4. Press the [▶] button followed by [ENT], that will select
the first bank 00 (the selected bank will blink).
Let's say we want to link banks 00 and 01.
5. Press the [ . ] key to register bank 00.
6. Use the [▶] button to go to bank 01 and press the [ . ] key
to register bank 01. (You can also rotate the dial selector
knob to rapidly scroll through the bank numbers)
If you selected another bank number by mistake, you
can deselect it with the [.] key.
The linked banks 00 and 01 will appear as follows:
00 01 02 03 04 05 06 07 08 09
10 11 12 13 14 15 16 17 18 19
20 21 22 23 24 25 26 27 28 29
30 31 32 33 34 35 36 37 38 39
7. Press the [9] key to save the search bank link selection and move to the following
settings for [DELAY TIME].
Delay time:
It's the time between signal interruption and squelch closing, for search to resume.
It can be set between 0.1 and 10 seconds, in 0.1 second increments.
40